Twin Tek Ignition Issues-----HELP
Thread Starter
|
Stage II
Joined: Sep 2013
Posts: 2
Likes: 0
From: NSW
Twin Tek Ignition Issues-----HELP
Hi Hope some one can give me some guidance on setting the initial timing and advanced curve...
I have a 2005 Dyna low rider
Recently run in s snd s 97 kit -Heads have been machined to match the cams and s and s kit - 211 cams - 42 Mikuni- Hyper charger with K and N screaming eagle pipes.
There are four pods on the Twin tek unit...Last two set at 6500rpm.
Im running an initial at 3 and advanced at 6 or 7. I find the rear cyclinder plug at times fouls and makes the bike jerk around and miss. New Plugs and leads solve this but same issue. I have increased the Mikuni main jet from a stock 160 to 165 cleaned carby out as well. Plugs look great after a few runs but just cant get the ignition timing right.
Any suggestions on the settings with my build?
I have a 2005 Dyna low rider
Recently run in s snd s 97 kit -Heads have been machined to match the cams and s and s kit - 211 cams - 42 Mikuni- Hyper charger with K and N screaming eagle pipes.
There are four pods on the Twin tek unit...Last two set at 6500rpm.
Im running an initial at 3 and advanced at 6 or 7. I find the rear cyclinder plug at times fouls and makes the bike jerk around and miss. New Plugs and leads solve this but same issue. I have increased the Mikuni main jet from a stock 160 to 165 cleaned carby out as well. Plugs look great after a few runs but just cant get the ignition timing right.
Any suggestions on the settings with my build?
Thread
Thread Starter
Forum
Replies
Last Post
magnum629c
General Harley Davidson Chat
16
May 17, 2019 08:26 AM
