Power vision install.
Thread Starter
|
Tourer
Joined: Jan 2016
Posts: 377
Likes: 63
From: South Carolina
Power vision install.
I was installing the power vision last night. The only place I see for the cable to run from the back of the bike to the handle bars is under the tank above the heads. I feel like it is going to get hot under there. I tucked them up under the tank as best as I could. Is this going to be a problem where I routed the cable? Thanks!
I was installing the power vision last night. The only place I see for the cable to run from the back of the bike to the handle bars is under the tank above the heads. I feel like it is going to get hot under there. I tucked them up under the tank as best as I could. Is this going to be a problem where I routed the cable? Thanks!
__________________
Jamie Long / Fuel Moto USA
The USA's Leader V-Twin EFI & Performance www.fuelmotousa.com
Contact 920-423-3309
Email jamie@fuelmotousa.com
Jamie Long / Fuel Moto USA
The USA's Leader V-Twin EFI & Performance www.fuelmotousa.com
Contact 920-423-3309
Email jamie@fuelmotousa.com
Thread Starter
|
Tourer
Joined: Jan 2016
Posts: 377
Likes: 63
From: South Carolina
Thanks. I took the same route has the cables coming from the fuse panel to the bars.
Thread
Thread Starter
Forum
Replies
Last Post
