Winter project 2015
Thread Starter
|
Tourer
Joined: Nov 2015
Posts: 497
Likes: 187
From: Dallas area
The lack of bearings is not a problem. Most car engines are like that, too. There was one spot that showed some wear but you can still see the original machining marks and this was after 58K miles.
Also, this is not the hybrid (SE) version with the orange cam plate. This is what is used on 2007-up models. Both of the cam chains are roller link.
PS - The oring mod can be made on the stock and SE cam plates, too.
Also, this is not the hybrid (SE) version with the orange cam plate. This is what is used on 2007-up models. Both of the cam chains are roller link.
PS - The oring mod can be made on the stock and SE cam plates, too.
Thread Starter
|
Tourer
Joined: Nov 2015
Posts: 497
Likes: 187
From: Dallas area
Scooter is running! 
Started right up, lifters clattered for about a minute until the oil pressure built. Ticking seems to be gone but hard to tell running with open exhaust (head pipes only). Hokey smokes it's LOUD! Kinda liking it.
Have to wait on it to cool off then put stuff together. Might get a ride in late today.
When that's done have to replace the rear tire and get it inspected for tag renewal.
Started right up, lifters clattered for about a minute until the oil pressure built. Ticking seems to be gone but hard to tell running with open exhaust (head pipes only). Hokey smokes it's LOUD! Kinda liking it. Have to wait on it to cool off then put stuff together. Might get a ride in late today.
When that's done have to replace the rear tire and get it inspected for tag renewal.
Thread Starter
|
Tourer
Joined: Nov 2015
Posts: 497
Likes: 187
From: Dallas area
I plan to get back your way at some point. Would like to see upstate NY again and see more of ME.
Thread
Thread Starter
Forum
Replies
Last Post
redbug2
Sportster Models
4
Dec 3, 2013 07:02 PM
