2009 Fatboy Handlebars/Risers Question
Thread Starter
|
Road Captain
Joined: Jun 2006
Posts: 529
Likes: 2
From: Watertown, MA
2009 Fatboy Handlebars/Risers Question
I saw a 2009 Fatboy with what looked like stock handlebars that were wired internally. However, at the handlebar clamps/riser and hand controls area it looked like the handlebars became narrower. If the bars are 1.25" what is the diameter at the risers area, 1"? I was also told (not sure if this was true) that the fatboys could have come with different handlebars. I've seen others where it didn't look like the bars became more narrow in those areas. Anyone else seen this?
Cruiser
Joined: May 2017
Posts: 226
Likes: 37
From: Sault Ste Marie,Mi
I saw a 2009 Fatboy with what looked like stock handlebars that were wired internally. However, at the handlebar clamps/riser and hand controls area it looked like the handlebars became narrower. If the bars are 1.25" what is the diameter at the risers area, 1"? I was also told (not sure if this was true) that the fatboys could have come with different handlebars. I've seen others where it didn't look like the bars became more narrow in those areas. Anyone else seen this?
Advanced
Joined: Mar 2017
Posts: 65
Likes: 2
From: Spring, TX
Did you have to replace all your cables (throttle/brake/switches) or were you able to use the stock cable setup?
Cruiser
Joined: May 2017
Posts: 226
Likes: 37
From: Sault Ste Marie,Mi
No-did not change any cables, but I made sure I didn't have to before swap.
Thread
Thread Starter
Forum
Replies
Last Post
