Any comments on HD "quick release" windshields ?
Road Warrior
Joined: Feb 2009
Posts: 1,345
Likes: 1
From: West of 47 IL
I just took a look to see and found there are a couple of very small, very minor scuff marks about the size of a BB. Each clamp has a small patch of clear plastic pad adhered on one end to keep the clamp from scuffing the tubes metal on metal. I could have done a better job of keeping them perfectly clean to help prevent. Really not an issue as the whole system works so well. On/off in seconds, two totally different rides. -stef
Last edited by busch; May 11, 2009 at 05:48 PM.
Club Member
Joined: Feb 2007
Posts: 2,404
Likes: 12
From: Haymarket, VA
I could'nt get my clamps to line up properly on the forks until I decided to read the directions. Lesson is, tighten screws until almost tight, close clamps, then finish tightning, will line up perfectly, I love mine. 
Outstanding HDF Member
Joined: Oct 2007
Posts: 2,018
Likes: 6
From: Edmond, Ok
I like mine.....It's been on a few short trips (nothing more than 450 miles in 1 day). It was a bit of a change for me- had to get used to the wind hitting my face at an angle, as opposed to straight on. No complaints, though.
Thread
Thread Starter
Forum
Replies
Last Post
Aroberts
General Harley Davidson Chat
14
Oct 14, 2008 03:22 PM
tsayles1
Dyna Glide Models
14
Aug 31, 2007 01:45 PM
