Quick thuner monster baffle question...
Thread Starter
|
Banned
Joined: Jan 2006
Posts: 17,265
Likes: 21
From: Los Angeles, CA
Quick thudner monster baffle question...
The thunder monster baffles I got do not have instructions (ebay). Do the lollipop side of the baffles face the rear of the pipe? That is the only thing that makes sense to me. the other question is how far back in the pipe should I put these. I am putting them in 36" fishtail straights. Thanks. Pics to come once they are mounted which should be tonight or tomorrow. One more question...should the round top part of the lollipop face up, down sideways, what? I have read that different angles give different results. Let me know how you did yours.
Last edited by anubisss; Jul 10, 2009 at 08:24 PM.
Elite HDF Member
Joined: Jan 2006
Posts: 4,357
Likes: 11
From: The Lone Star State
6 inches from end of pipe is where you drill your mounting hole. I can't remember where my lolipop was positioned. I know I drilled the hole on the inside sidewall of the pipe. Lollipop facing towards the rear of the bike. By the way, BCT has great customer support, so you can call them and they will give you the exact direction.
Grand HDF Member
Joined: May 2008
Posts: 4,624
Likes: 189
From: Newcastle, Ca.
A 16p nail can work or a large screw... Depending on the hole size, sometimes I start with a smaller drill size cause its easier to make sure the hole is in the right sport, then use the correct drill bit.
Thread Starter
|
Banned
Joined: Jan 2006
Posts: 17,265
Likes: 21
From: Los Angeles, CA
Okay. I used a small screwdriver that was rather sharp and that worked fine. Baffles are mounted in the pipes. Quite a bit easier to do than I would expect. Next to put them on the bike.
Thread
Thread Starter
Forum
Replies
Last Post
