Well guys I installed the LED fuel gauge. Installation was a bit difficult. You have to remove the old harness and cannon plug conector, install the new harness and then clip in the wires into the new cannon plug. Unfortunately, the directions refer you to the service manual oftne, but I did it without. The hardest part was rerouting the single gray wire under the tank and connecting in the speedometer harness. This must be for the low fuel light indicator know doubt. Overall, the LED is quite nice. It lights up well like most LED's do, is much easier to see sitting on the bike, and should be very accurate. Nice upgrade for $100.

 

Hey bannana boat,

You might of talked me into one. I have been checking into the one that has a voltage meter too.

David

 

jlnbjlljk

 

Hey BB, can you take a picture of your new guage?

Ryan

 

Yeah!

 

Wow... what will they come up with next...

oh yeah, the Ball warmers.

 

They already got em...but you use them to hold onto the handlebars...ummm...I mean Corbin makes a heated seat.