wont shift after replacing inner primary
Seasoned HDF Member
Joined: Jun 2006
Posts: 30,881
Likes: 32,990
From: King George, VA
Are you saying you installed the sprocket can first then the outer can plate then the nut then the spring plate?
The spring plate is only held on by the nut shaft. How did you get it to stay in place?
The spring plate is only held on by the nut shaft. How did you get it to stay in place?
Thread Starter
|
Novice
Joined: Jan 2011
Posts: 18
Likes: 0
From: Spring Hill, Florida
no, somehow in my confusion/frustration i installed everything as it should be except i put the washer/spacer behind the outer cover instead of on the outside behind the nut of the compensator
Last edited by mudkaiser; Mar 25, 2013 at 07:24 PM.
Thread
Thread Starter
Forum
Replies
Last Post
