Engine Head Temp Sensor
Elite HDF Member
Joined: Dec 2010
Posts: 4,501
Likes: 26
From: Sheboygan,Wi
You can find you part number and order it from here.
Also you can see an explode view of where it goes.
http://www.shopronniesharleydavidson...partfinder.htm
Also you can see an explode view of where it goes.
http://www.shopronniesharleydavidson...partfinder.htm
Road Master
Joined: Oct 2008
Posts: 970
Likes: 19
From: Philippines
Just had to replace mine about a month ago. The Engine Temp Sensor is located at the rear of the front cylinder. Access it from the left side of the bike. There is a little trick to getting it in and out. You must use a deep well socket to clear the electrical connection on top of the sensor however the overall length of the deep well socket and attached ratchet will make contact with the rear cylinder. Use a hack saw and cut 1 inch off the end of the socket. The socket and ratchet will then easily fit between the cylinders. This is an easy replacement item once you have the correct length socket.
Thread
Thread Starter
Forum
Replies
Last Post
