New 883 Iron Owner. Need a little help! Siren wire?
Thread Starter
|
Stage IV
Joined: Nov 2009
Posts: 4
Likes: 0
New 883 Iron Owner. Need a little help! Siren wire?
Hey there everyone,
Just picked the wife up a 2010 Iron. She's absolutely loving it! What a great bike.
I need a little help, I had the factory alarm system installed and dealer programmed. Everything is working fine. Lights now flash, and security system id on speedo flashes when armed.
What I'm trying to do now is install the the Radio Shack Siren. But I cannot find the wire any where. I've searched hi and low, no luck.
I just had the battery out, and the factory computer out, I still can't find the three wire plug.
Can anyone point me in the right direction? Perhaps a picture of the actual wire?
It's listed here in the .pdf as (2. Three-pin connector [142B] on vehicle harness)
http://www.harley-davidson.com/en_US...ts/-J03843.pdf
Just picked the wife up a 2010 Iron. She's absolutely loving it! What a great bike.
I need a little help, I had the factory alarm system installed and dealer programmed. Everything is working fine. Lights now flash, and security system id on speedo flashes when armed.
What I'm trying to do now is install the the Radio Shack Siren. But I cannot find the wire any where. I've searched hi and low, no luck.
I just had the battery out, and the factory computer out, I still can't find the three wire plug.
Can anyone point me in the right direction? Perhaps a picture of the actual wire?
It's listed here in the .pdf as (2. Three-pin connector [142B] on vehicle harness)
http://www.harley-davidson.com/en_US...ts/-J03843.pdf
Thread
Thread Starter
Forum
Replies
Last Post
