When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
been searching on here how to push start my bike and i have it down now except for one thing...everyone says to "pop" the clutch. do they mean to just let it go completely so it engages quickly or are you supposed to gradually let out the lever?...also just in case the bike doesnt turn over, how bad does it buck when in gear but it doesnt start? are my chances of goin down pretty good? haha
Just let it go all the way at once. Also, use 2nd or 3rd gear to make turning the engine over easier. I get a buddy to push and then right when I want to pop the clutch I jump up and land on the seat at the same time I let the clutch out. Helps keep the wheel from slipping.
Note: It looks like your sig pic is a Nightster. You're going to have a much harder time bumping an EFI bike than a carb.
I had to push start my bike one time, thank god I was on a hill lol. The only "mistake" I did was start it in 1st gear, it would have been alot easier and safer in a higher gear, like 2nd or 3rd
2nd gear usually works better. However, your avatar pic appears to be EFI bike. They won't jump start, unless the problem is the starter. Gotta have battery to run the fuel pump.
If your battery is too low, the EFI will not operate. If your fuel pump won't power up, you're done.
Exactly. Been there, done that.
buying a new battery: OK
But let check your regulator, could be toasted, mine did, changed by my indy under warranty, there was a recall on all sportsters built between oct 2011 to march 2012, IIRC.
7 Surprising Harley-Davidson Products that Are Not Motorcycles
Slideshow: The bar-and-shield logo shows up on far more than motorcycles, some of the company's most unexpected products have nothing to do with riding.
Slideshow: From the troubled AMF years to modern misfires, these bikes earned reputations for reliability issues, questionable engineering, or disappointing performance.
Crazy Bunderbike Build Looks Amazing, But Is It Impossible to Ride?
Slideshow: The Swiss custom shop has taken a Harley Softail and stretched it into something so long and low that it looks closer to a rolling sculpture than a conventional motorcycle.
Engraved Rebellion: Inside Bundnerbike's Glam Rock II
Slideshow: A standard cruiser becomes an intricate metal canvas in the hands of a Swiss custom house known for pushing Harley-Davidson platforms far beyond their factory brief.
Slideshow: Harley-Davidson's challenges aren't abstract; they show up in dropping shipments, shrinking dealer traffic, and strategic decisions that aren't yet translating into growth.