risers = headlight issues :(
Thread Starter
|
Cruiser
Joined: Feb 2012
Posts: 212
Likes: 3
From: West Seneca,NY
risers = headlight issues :(
I went from a little tiny 2 inch riser to a nice 10 inch riser the issue is the power wire that goes from the high/low switch on the bars is to short. What do I do? The headlamp is stock and the wire just goes to the side. It seems really thick to be a positive and negative only wire so do they sell extensions for it? Do I need a new head light? What do you do?
Road Warrior
Joined: Jul 2011
Posts: 1,345
Likes: 1
From: coastal NC
If you can't find an extension, I added additional length of wiring to my harness when I relocated my speedo and added pullback risers. Cut it, figure out how much more wiring you need (6 inches, etc etc) stagger your cuts of course, solder the new wiring in, and wrap it all with electrical tape. Nobody will know but you.
Road Warrior
Joined: Jul 2011
Posts: 1,345
Likes: 1
From: coastal NC
They should be different colors. Just do one at a time if need be. I eliminated the big bulky connectors that were in my headlight bucket when I switched to a bottom mount headlamp. Just be patient.
Thread
Thread Starter
Forum
Replies
Last Post
