Turn Signal HELP
Thread Starter
|
Cruiser
Joined: Dec 2012
Posts: 125
Likes: 0
From: NY
Turn Signal HELP
I have a 2012 Sportster 883, I put the Arlen Ness Direct Bolt On LED Turn Signals for the rear. It is throwing a code B1121 & B1122, I called Arlen Ness and they told me the turn signal module had to be reprogrammed to accept the LED lights and there is a way to do it threw the buttons on the bars. Does anyone know the procedure or anyone ever go threw this? Any help would be great. Thanks
Road Warrior
Joined: Feb 2011
Posts: 1,342
Likes: 8
From: Milwaukee, WI
Check out this thread. This should be what you are looking for!
Edit: The link doesn't seem to be working. I'll just cut and paste the steps.
step # 1. move handle bar kill switch to off position
step # 2. turn your ignition key: on-off, on-off then on
step # 3. hit the left turn signal twice.
your turn signals and indicator light will flash 1 - 3 flashes
step # 4. hit the right turn signal once.
turn signals and indicator light will flash once.
step # 5. hit the right turn signal once.
turn and indicator signals will flash twice.
step # 6. hit right turn signal once.
turn and indicator signals will flash three times.
step # 7. hit left turn signal once.
turn and indicator signals flash to indicate error code
(see error code thread)
step # 8. to now clear codes, hit left turn signal and hold down for 6 seconds until confirmation.
turn and indicator signals flash twice.
step # 9. turn the ign switch to off
Edit: The link doesn't seem to be working. I'll just cut and paste the steps.
step # 1. move handle bar kill switch to off position
step # 2. turn your ignition key: on-off, on-off then on
step # 3. hit the left turn signal twice.
your turn signals and indicator light will flash 1 - 3 flashes
step # 4. hit the right turn signal once.
turn signals and indicator light will flash once.
step # 5. hit the right turn signal once.
turn and indicator signals will flash twice.
step # 6. hit right turn signal once.
turn and indicator signals will flash three times.
step # 7. hit left turn signal once.
turn and indicator signals flash to indicate error code
(see error code thread)
step # 8. to now clear codes, hit left turn signal and hold down for 6 seconds until confirmation.
turn and indicator signals flash twice.
step # 9. turn the ign switch to off
Last edited by sioux565; Jun 18, 2014 at 01:56 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Reindeer
Ignition/Tuner/ECM/Fuel Injection
11
Sep 27, 2012 06:34 AM
