13 FLHTK Chubby Bagger Bars install
Thread Starter
|
Road Master
Joined: Sep 2010
Posts: 1,138
Likes: 457
From: Littleton CO
13 FLHTK Chubby Bagger Bars install
Finally got the last piece to the puzzle, the bars arrived today!!
So.... I have
10" Wild1s black Chubby Bagger Bars
CVO Twist Grip Sensor
+4 Magnum black braided clutch cable
+4 Drag Specialties brake line. May not need, but wanted to have on hand.
Urethane riser bushings
Black clutch and brake levers.
And the correct Molex connector tool.
Now if the temps would get above freezing, so I don't break any brittle plastic pieces, I could get them swapped.
I am excited to get started!!!
So.... I have
10" Wild1s black Chubby Bagger Bars
CVO Twist Grip Sensor
+4 Magnum black braided clutch cable
+4 Drag Specialties brake line. May not need, but wanted to have on hand.
Urethane riser bushings
Black clutch and brake levers.
And the correct Molex connector tool.
Now if the temps would get above freezing, so I don't break any brittle plastic pieces, I could get them swapped.
I am excited to get started!!!
Thread Starter
|
Road Master
Joined: Sep 2010
Posts: 1,138
Likes: 457
From: Littleton CO
Gonna probably remove the tank, and yeah that, cover everything well.
This will be my third set of Chubbys I have installed. Did 2 sets on 2 different Ultras for the Ex. Now it's my turn!!!
This will be my third set of Chubbys I have installed. Did 2 sets on 2 different Ultras for the Ex. Now it's my turn!!!
Thread Starter
|
Road Master
Joined: Sep 2010
Posts: 1,138
Likes: 457
From: Littleton CO
Well..... I am into my bar swap. Had to buy new heated grips today. The throttle grip was sticking, it must have been deformed from the heat. $290.00 later and all is well. Hopefully bars will be installed on bike tomorrow. Then clutch cable swap. I am waiting on iPod interface, decided might as well do that while the outer fairing was removed.
A $450.00 job has now turned into over $1,000 job. LOL
A $450.00 job has now turned into over $1,000 job. LOL
Banned
Joined: Apr 2008
Posts: 2,492
Likes: 10
Finally got the last piece to the puzzle, the bars arrived today!!
So.... I have
10" Wild1s black Chubby Bagger Bars
CVO Twist Grip Sensor
+4 Magnum black braided clutch cable
+4 Drag Specialties brake line. May not need, but wanted to have on hand.
Urethane riser bushings
Black clutch and brake levers.
And the correct Molex connector tool.
Now if the temps would get above freezing, so I don't break any brittle plastic pieces, I could get them swapped.
I am excited to get started!!!
So.... I have
10" Wild1s black Chubby Bagger Bars
CVO Twist Grip Sensor
+4 Magnum black braided clutch cable
+4 Drag Specialties brake line. May not need, but wanted to have on hand.
Urethane riser bushings
Black clutch and brake levers.
And the correct Molex connector tool.
Now if the temps would get above freezing, so I don't break any brittle plastic pieces, I could get them swapped.
I am excited to get started!!!
Mark
Thread
Thread Starter
Forum
Replies
Last Post
Talldog
Touring Parts
5
Dec 9, 2014 12:41 PM
