Handlebar question
Thread Starter
|
Cruiser
Joined: Feb 2017
Posts: 125
Likes: 30
From: Bayou State
Handlebar question
i have a 2017 CVO limited and I installed Khrome Werks +2 narrow sweepers #300518 on my bike. Went riding today and a buddy of mine tried them out and wants me to install a set on his bike, he has a 2012 limited
My question is has anyone installed these bars on the same bike and did you have to change any cables or add wire extensions
Thanks
Terence
My question is has anyone installed these bars on the same bike and did you have to change any cables or add wire extensions
Thanks
Terence
Extreme HDF Member
Joined: Sep 2010
Posts: 14,744
Likes: 402
From: Phoenix '53, '88, '09 Big Twins
2009 flhtc, I did the 300077 2+2 and the only change will be the clutch cable- I have not yet swapped the cable, mine is re-routed but it is ugly.
all the wiring will be good....not sure about your heated grips though
the brake lever requires a shim be applied to prevent the switch breaking...this will give the system positive pressure.
you may need to slightly loosen the brake line fitting and adjust the angle, have a rag ready the catch any seep.
mike
all the wiring will be good....not sure about your heated grips though
the brake lever requires a shim be applied to prevent the switch breaking...this will give the system positive pressure.
you may need to slightly loosen the brake line fitting and adjust the angle, have a rag ready the catch any seep.
mike
Thread
Thread Starter
Forum
Replies
Last Post
