08 UC Alarm
1. Remove right hard bag
2. Remove right side cover
3. Remove 2 hex nuts (see photo below)
4. Remove module w/ the plastic mounting panel
5. Locate siren plug on back side of mounting panel (see photo below)
6. Unplug siren plug from plug cap
7. Strip approx. 1/4" of the insulation of red wire on Radio Shack siren
8. Strip approx. 1/4" of the insulation of black wire on Radio Shack siren
9. Insert red wire into the hole for the brown wire of thesiren plug
10. Insert black wire into the hold for the green wire of the siren plug
11.Insert siren plug into the cap to hold wires in place
12. Attachsiren to back of mounting panel using double sided tape
13 Reinstallall parts in reverse order
The wiring is temporary until the Delphi plug I ordered arrives.


Just put my siren on my RK, did the same as you and it works perfect.
Were did you find the Delphi plug? i've been looking and just not finding it.
Thanks
Jeff
Trending Topics
I'm finding that there may not be a mate for it. Some of these type plugs are designed to plug into an object, i.e. sensor, wiper motor, etc. and not into another plug. I'm still looking and will holler with what I find......... or don't find. But hey........ it's working!
The Best of Harley-Davidson for Lifelong Riders
The difference between using the RS alarm and the Harley Smart siren is the fact that the RS siren does not have a self contained battery whereas the Harley one does... Does that matter? Cutting the power souce to the RS siren will silence it... But the Harley Siren will continue till it's own battery dies.






