Power Commander III USB Update
Thread Starter
|
Cruiser
Joined: Jul 2007
Posts: 103
Likes: 0
From: Springfield, IL.
Power Commander III USB Update
A few days ago, I posted I was getting some Ghost Codes on the bike stating it was having some sort of misfire on the front and rear cylinder..
Took it back to the Dyno Shop, and they took a good look at the bike today. They made a call to Power Commander, and found out there is a New Firmware Update for the Power Commander.
The New Firmware is Update 2.2.5
After installation of the new firmware, and reloading of the map for my bike..
Took it for a little spin tonight. Verying the speed up and down, using the cruise control, and trying to induce a misfire under the same conditions that it happened over the weekend. I am glad to report after riding 190+ miles tonight...No Misfire Codes on the Bike at this point.
I hope this information helps those out that might experience the same problem with any ghost misfire codes on their bike..
Thanks,
ToadsUltra07
Took it back to the Dyno Shop, and they took a good look at the bike today. They made a call to Power Commander, and found out there is a New Firmware Update for the Power Commander.
The New Firmware is Update 2.2.5
After installation of the new firmware, and reloading of the map for my bike..
Took it for a little spin tonight. Verying the speed up and down, using the cruise control, and trying to induce a misfire under the same conditions that it happened over the weekend. I am glad to report after riding 190+ miles tonight...No Misfire Codes on the Bike at this point.
I hope this information helps those out that might experience the same problem with any ghost misfire codes on their bike..
Thanks,
ToadsUltra07
Thread
Thread Starter
Forum
Replies
Last Post
