PC V on 08 with ABS
Thread Starter
|
Cruiser
Joined: May 2007
Posts: 112
Likes: 0
From: League City, Texas
PC V on 08 with ABS
Well I just finished putting my Fuel Moto PC V and SEAC on my road king. All you guys considering putting a PC V on an ABS bike here's a tip you may have already heard about. Borrow a dremel tool with a cutting disc from a buddy if you don't have one. You will have to trim the ECM tray to get everything back under the seat and a dremel would have made it a ton easier. The air filter bracket that has to come off to install the high flow backing plate is a bit of trouble but is doable with the tank on the bike. Now if my V&H dresser duals and Monster ovals will get here i'll be good to go. Before you start yelling, i cleared it with Jamie to ride the bike with the PC and the SEAC before I get the pipes on it. He says it'll run a bit richer but it's not a problem. Sorry about no photos....i'm not that advanced in cyberworld and my kid wasn't here.
Thread Starter
|
Cruiser
Joined: May 2007
Posts: 112
Likes: 0
From: League City, Texas
Here's the url to a thread with pictures of another forum member that did the install on an 08 touring bike. like i said above if you have a dremel it wouldn't take 20 minutes to do the whole thing. I used a sabre saw with a fine blade then cleaned up the edges with a box cutter.
https://www.hdforums.com/forum/touri...ml#post4722155
https://www.hdforums.com/forum/touri...ml#post4722155
Thread
Thread Starter
Forum
Replies
Last Post
