Manual miss print or difference install vs. check
Thread Starter
|
Tourer
Joined: Jul 2009
Posts: 280
Likes: 1
From: Wisconsin
Manual miss print or difference install vs. check
OK The torque listed when changing brake lines for the banjo to the ABS module is 12.5 - 14.5 ft-lbs, both in section C1 and in the back of the manual where all the bolt toques are listed.
But, in the critical fasteners it is listed as 14.5 - 22 ft-lbs?
Seems like a miss print to me.
Anyone know for sure?
This is on a '08 Ultra.
Thanks
But, in the critical fasteners it is listed as 14.5 - 22 ft-lbs?
Seems like a miss print to me.
Anyone know for sure?
This is on a '08 Ultra.
Thanks
Ultimate HDF Member
Joined: Jan 2008
Posts: 6,532
Likes: 132
From: SoCal
I'm not sure if a brake line banjo bolt is defined as a critical fastener because of it's design. I would tighten it to the lower tq spec, it would probably break or distort at the higher rating, due to the design of banjo bolts.
Thread
Thread Starter
Forum
Replies
Last Post
fatbob_jay
Dyna Glide Models
7
May 9, 2019 08:58 PM
