Bike Loading Ramp - single use..Cheep.. ideas?
Late to the party, but I made two ramps and each used three 2x6s. Both ramps I placed two 2x6s side by side. The difference was the underneath. On one ramp I cut the 2x6 into blocks and placed them horizontally every foot. On the other ramp I ran ran a third 2x6 down the middle underneath to cover th seam. This method worked great. The boards didn't sag at all with me and the bike. I then used the metal ramp ends you buy at Tractor Supply.
Good luck!
Good luck!
Elite HDF Member
Joined: Dec 2009
Posts: 4,598
Likes: 14
From: navarre ohio
just a simple 2x6-8 will be fine. i have used 2x4's to load smaller bikes. weren't you going to remove the front end or something for shipping? just get a few friends to help lift it in. 4 men can easily lift a bike.
Seasoned HDF Member
Joined: Jan 2011
Posts: 28,842
Likes: 16,583
From: Wisconsin, USA
There. Fixed it for ya.
Elite HDF Member
Joined: Sep 2005
Posts: 3,947
Likes: 5
From: Ontario, Canada
Could it be any simpler.
HD Forum Stories
The Best of Harley-Davidson for Lifelong Riders
7 Times Harley-Davidson Chucked Tradition Out the Window
Verdad Gallardo
7 Surprising Harley-Davidson Products that Are Not Motorcycles
Verdad Gallardo
8 Best Harley-Davidson Motorcycles Ever
Pouria Savadkouei
10 Worst Harley-Davidson Motorcycles Ever
Pouria Savadkouei
Killer Custom's Jail Break Is The Breakout That Refused to Blend In
Verdad Gallardo
Crazy Bunderbike Build Looks Amazing, But Is It Impossible to Ride?
Verdad Gallardo
Harley-Davidson Reveals Super Cool Cafe Racer Concept
Verdad Gallardo
Engraved Rebellion: Inside Bundnerbike's Glam Rock II
Verdad Gallardo
10 Motorcycles You Should Never Buy
Joe Kucinski
Thread
Thread Starter
Forum
Replies
Last Post