2014 Street Glide Issues
Thread Starter
|
Cruiser
Joined: Apr 2014
Posts: 126
Likes: 0
From: Michigan
Yes, as stated above.
We are all very mechanically inclined and all of the basics have been checked. Going to give it another go here after work.
Thread Starter
|
Cruiser
Joined: Apr 2014
Posts: 126
Likes: 0
From: Michigan
In talking with one of my buddies who was working on it with me, we may have not had the antenna plugged in, which probably ties into the security system, as one of the first replies stated.
Extreme HDF Member
Joined: Sep 2010
Posts: 14,744
Likes: 402
From: Phoenix '53, '88, '09 Big Twins
if the fuel pump runs that also shows that the system relay is correct- and most probably that the run/stop switch and wiring is good.
try the jumper wire to test primary starting circuit vs secondary starting circuit.
if the starter cranks, then your problem is likely the connections to the right hand controls ( and as above neutral, clutch switch etc.)
mike
try the jumper wire to test primary starting circuit vs secondary starting circuit.
if the starter cranks, then your problem is likely the connections to the right hand controls ( and as above neutral, clutch switch etc.)
mike
Last edited by mkguitar; Apr 17, 2014 at 12:53 PM.
Outstanding HDF Member
Joined: Oct 2008
Posts: 2,981
Likes: 48
From: Northern Illinois
Check the wiring plug that snaps in to the ignition switch, maybe not seated correctly, or got pulled out.
You said the bike had an alarm system, does if have a siren too? If not, when you turn the switch to the run position, do the turn signals flash? If they do, you know it's being caused by the alarm system not getting a signal from the Fob.
Good luck!
You said the bike had an alarm system, does if have a siren too? If not, when you turn the switch to the run position, do the turn signals flash? If they do, you know it's being caused by the alarm system not getting a signal from the Fob.
Good luck!
Thread Starter
|
Cruiser
Joined: Apr 2014
Posts: 126
Likes: 0
From: Michigan
Hmm...Neutral light was on, and no signals flashing. The only connections that we can think back that were not connected were the two "dummy" plugs as we call them up under the bottom panel. One we think is for the Aux connection and the other not sure. The plug in under the very bottom of the fearing and don't appear to go to anything. We'll see once we have everything plugged in.
Seasoned HDF Member
Joined: Oct 2006
Posts: 5,977
Likes: 85
From: Nevada
IF the fuel pump primes...then the security system is disarming.
the fuel pump will not run if the security is armed, that also shows that the system relay is correct- and most probably that the run/stop switch and wiring is good.
try the jumper wire to test primary starting circuit vs secondary starting circuit.
if the starter cranks, then your problem is likely the connections to the right hand controls ( and as above neutral, clutch switch etc.)
mike
the fuel pump will not run if the security is armed, that also shows that the system relay is correct- and most probably that the run/stop switch and wiring is good.
try the jumper wire to test primary starting circuit vs secondary starting circuit.
if the starter cranks, then your problem is likely the connections to the right hand controls ( and as above neutral, clutch switch etc.)
mike
HD Forum Stories
The Best of Harley-Davidson for Lifelong Riders
8 Best Harley-Davidson Motorcycles Ever
Pouria Savadkouei
10 Worst Harley-Davidson Motorcycles Ever
Pouria Savadkouei
Killer Custom's Jail Break Is The Breakout That Refused to Blend In
Verdad Gallardo
Crazy Bunderbike Build Looks Amazing, But Is It Impossible to Ride?
Verdad Gallardo
Harley-Davidson Reveals Super Cool Cafe Racer Concept
Verdad Gallardo
Engraved Rebellion: Inside Bundnerbike's Glam Rock II
Verdad Gallardo
10 Motorcycles You Should Never Buy
Joe Kucinski
10 Things Harley-Davidson Needs to Fix in 2026
Verdad Gallardo
Southpaw Super Glide: A Left-Hand-Drive 1979 Harley FXE Built to Fit the Rider
Verdad Gallardo
Thread Starter
|
Cruiser
Joined: Apr 2014
Posts: 126
Likes: 0
From: Michigan
It's not in any way, shape, or form a "wiring" issue. It maybe a connector "not plugged in all the way", but this is not a short we are dealing with here. It is probably either a issue with the security system, or something isn't plugged in all the way. The bike is brand new with 78 miles on it.
Hopefully once we get everything all plugged in and double check the connectors it'll be fine.
I was just wondering if anyone else that maybe had their 14' apart to have painted, as in this case, who didn't have any issue, or had a similar issue.
Hopefully once we get everything all plugged in and double check the connectors it'll be fine.
I was just wondering if anyone else that maybe had their 14' apart to have painted, as in this case, who didn't have any issue, or had a similar issue.
Extreme HDF Member
Joined: Sep 2010
Posts: 14,744
Likes: 402
From: Phoenix '53, '88, '09 Big Twins
so check for security key icon, flashing signal and siren if you have
mike