Problem with security system
Last edited by theglider; May 11, 2014 at 06:35 PM.
Both are available for purchase.
Are you sure the bike has the factory security system installed?
After about a minute, they shut off.
If not, your not going to be doing anything with the factory security system without a programmed FOB.
If you know the PIN, then wait for the lights to stop flashing.
Then without moving the bike, turn the ignition switch on.
Very quickly press and hold both turn signal buttons at the same time until you see the 5 dashs show up in the speedo.
Now you can enter the PIN.
Press the left signal button x times (whatever the first PIN number is)
Then press the right signal button to move to the next number.
Press the left signal button x times (whatever the second PIN number is)
Continue to the last PIN number and then press the right signal button again.
The security system is now disabled and the bike should start.
Note: You will need to do this each and every time you turn the ignition off.
For that reason, I am skeptical that it even has a factory security system.
If it did, how were you able to get the bike started in the first place without the FOB?
Probably isn't going to be that easy. They are not just going to take it back and give you a different one after you already bought this one.
if you don't have a fob, but you can start the bike, then you don't have factory installed security. if the flashing lights do not go out after app. 30 seconds, you don't have security, you turned the flashers on. if thats the case, then turn the ignition on again, and press the left and right signal switches and turn them off so you don't drain your battery.
Trending Topics
you sure you don't have the hazard lights on??
The Best of Harley-Davidson for Lifelong Riders
Last edited by grbrown; May 12, 2014 at 08:05 AM.







