Throttle/clutch cable routing??
Thread Starter
|
Road Captain
Joined: Aug 2007
Posts: 626
Likes: 0
From: FUAC
Throttle/clutch cable routing??
Hey guys..could use some opinions on this. I have semi pullback drag bars on my Dyna, with6" risers. I was wondering how you guys routed your shortened clutch cables, throttle cables and electrics? I am running the wiring harness (wrapped in braided stainless covers)for the electrical, through cutout in thetriple trees. My question though is I don't really want to run my throttle cables through the front forks/ trees if there is a way to put them just ahead of the gas tank without rubbing. Same goes for the clutch cable. I would really appreciate any photos of how you ran your cables and where they may be secured as to not interfere with turning or hitting the tank and rubbing.
HDforums are the best!!
Swamphunter
HDforums are the best!!
Swamphunter
Road Captain
Joined: Jan 2008
Posts: 502
Likes: 0
From: currently NC
RE: Throttle/clutch cable routing??
Route your cables the same way they were and use cable clamps: http://search.realhog.com/search.asp...rch_button.y=4. If your cables are too long or too short just get the proper length and all will be fine
Thread
Thread Starter
Forum
Replies
Last Post
