Riser question

Reply Subscribe

Thread Tools

Search this Thread

Feb 18, 2008 | 03:36 PM

PB565

Thread Starter

Intermediate

Joined: Jun 2007

Posts: 39

Likes: 0

From:

Riser question

So today I install the 2 1/2" aluminium pullback risers I ordered from that big aftermarket catalog for around 42 bucks. Upon tightening everything back up, not over tightening in my opinion, I notice one of the risers cracks. F**k! Anyway I put the old ones back on and now I'm contemplating my next move. Do I order original HD pullback risers? Are they made of the same cheap aluminium? How about just better quality aftermarket? Any advice guys? Thanks in advance.

Feb 18, 2008 | 03:41 PM

bikerdog134

Road Master

Joined: May 2007

Posts: 883

Likes: 0

From:

RE: Riser question

send them back, maybe they will stand good for them. it could have been a defect. its worth a shot

Feb 18, 2008 | 03:42 PM

The Baron

Banned

Joined: Jan 2008

Posts: 1,899

Likes: 7

From:

RE: Riser question

Never seen a riser crack. I'd send them back and order another brand.

Feb 19, 2008 | 08:25 AM

hk_shooter

Outstanding HDF Member

Joined: Jul 2007

Posts: 3,299

Likes: 2

From: By the "Betty water and the Wire"

RE: Riser question

I got mine, already coated from eBay. But they seem pretty heavy to be aluminum. And they have the bar&shield cast into the top clamp. I'd send them back, even if they are aluminum they shouldn't of cracked unless you really torqued the crap out of them.

Feb 19, 2008 | 09:58 AM

fiend138

Road Captain

Joined: Aug 2007

Posts: 667

Likes: 1

From: Vancouver Wa.

RE: Riser question

Most likely they are forged ALU, it is strong enough for to be a riser but it is weaker than billet part. I have heard of this before, send them back and get another set.