Just finished installing flush mount caps. Take a look. Only one more project to do before the riding season is up here and that is to send the seat out to be jelled.

[IMG]local://upfiles/7604/F16C71684BCA44FF9008A375BA1EAC89.jpg[/IMG]

[IMG]local://upfiles/7604/FA6E649973D84B2C8A0E3DEB9B4B992C.jpg[/IMG]

 

looks good Richie, I like the clean look of those....easy install?

 

Looks nice.

My buddy just bought a new nightster and is thinking about getting the flushmount gas cap. Do they sell only the cap (without the fuelgauge)?

 

The cap and gas gauge come as a set. The install was easy instructions say to remove the gas tank to get to the wires but it wasn't needed. I could reach the connector from under the tank.
Took about half and hour for both.

 

Looks good Richie, I think Harley will sell plenty of these.

 

Good job pops.. Looks great!!! Catch ya later!!!
Rick

 

I'm in the process of installing those gas caps and gas gauge also. Did you have to loosen the gas tank and move it up without disconnectingor was yourwiring long enough to allow you acess without moving the tank. Thanks,Tom

 

nope looked under the tank on the left side (as if you were sitting on it) found the connector right there.