14 in handlebars for Switchback
Thread Starter
|
Intermediate
Joined: Aug 2018
Posts: 46
Likes: 6
From: United States
14 in handlebars for Switchback
I have a 2012 Switchback with an aftermarket batwing fairing:
https://hoppeindustries.com/products/quadzilla-for-switchback
The bike has Helibars on it and I want to get some 14 in Wild 1 bars put on. I'm not sure if I should be getting standard 14 in apes or 14 in Bagger bars. The Bagger bars seem to be the better option being that they are curved on the bottom to clear a fairing. Would I be safe getting either of these bars?
The stereo head unit is about 9 inches across. This is the measurements from Wild 1 for standard 14 inch apes:
36.5" WIDE, 9" CENTER, 10" PULLBACK, 42° WRIST ANGLE
Sounds like the bars would be cutting it close in clearing the head unit.
https://hoppeindustries.com/products/quadzilla-for-switchback
The bike has Helibars on it and I want to get some 14 in Wild 1 bars put on. I'm not sure if I should be getting standard 14 in apes or 14 in Bagger bars. The Bagger bars seem to be the better option being that they are curved on the bottom to clear a fairing. Would I be safe getting either of these bars?
The stereo head unit is about 9 inches across. This is the measurements from Wild 1 for standard 14 inch apes:
36.5" WIDE, 9" CENTER, 10" PULLBACK, 42° WRIST ANGLE
Sounds like the bars would be cutting it close in clearing the head unit.
Thread
Thread Starter
Forum
Replies
Last Post
