No Spark??
Seasoned HDF Member
Joined: Mar 2010
Posts: 38,239
Likes: 6,302
From: Honah Lee
I am pretty sure a 2001 has a crank sensor just to right of the end of the oil filter. On the left side of the crank case. It may be that. If it does not get a signal, it ECM will not tell it to fire.
Last edited by Jackie Paper; Mar 16, 2017 at 06:41 AM.
1st Gear
Joined: Apr 2017
Posts: 5
Likes: 0
From: Washburn Wi
UPDATE I followed the instructions in the HD Bible Manual "the big one" and tested the electrical system. Skip the bull **** guys and do it all from the end to save yourself a couple hours and test the Crank Position Sensor first! Mine was way under specs. Bought a new S&S sensor and WAM, fired right up!
Advanced
Joined: Jul 2016
Posts: 56
Likes: 4
From: Washington
Did that include the plug wires? As I recall they should run something like 5-8k ohm per 1' of plug wire. Mine read nil. Replaced them and it started.
1st Gear
Joined: Apr 2017
Posts: 5
Likes: 0
From: Washburn Wi
Yes sir! Cam sensor is another! TY!
IMO the most likely to go is the Camshaft Position Sensor. That's the last thing the book had me check and what I had suspected to be wrong. Chatter on the forums has it saying early builds had an issue..........Had I skipped all the other inspections and jumped to the end I would have save a lot of time. Just say'n
IMO the most likely to go is the Camshaft Position Sensor. That's the last thing the book had me check and what I had suspected to be wrong. Chatter on the forums has it saying early builds had an issue..........Had I skipped all the other inspections and jumped to the end I would have save a lot of time. Just say'n
Thread
Thread Starter
Forum
Replies
Last Post