FLush Fuel Gauge Install
Stellar HDF Member
Joined: Mar 2006
Posts: 2,395
Likes: 153
From: Utah
RE: FLush Fuel Gauge Install
The purpose of the grey wire is so that your new gauge will feed a continual power supply to the fuel low warning light in your speedo. You have to run it from under your tank up the front of the tank under the speedo housing and connect it as shown in your installation instructions. I don't recall which terminal you connect it to, but the instruction tells you.
You need to be careful with those Delphi connectors, too.
C#
You need to be careful with those Delphi connectors, too.
C#
Cruiser
Joined: Dec 2005
Posts: 162
Likes: 2
From:
RE: FLush Fuel Gauge Install
If you don't have one, get a shop manual. It will tell you where to land the grey wire. If I had it to do over again, I would cut the wire going into the connector and use a butt connector with shrink wrap to connect. Taking the wires out of that connector was not fun. The end result is worth it.
Thread
Thread Starter
Forum
Replies
Last Post
Crushrus
Dyna Glide Models
35
Feb 13, 2015 09:20 PM
