08 crossbones.. running legends with turn signal??
Thread Starter
|
6th Gear
Joined: Jan 2009
Posts: 10
Likes: 0
08 crossbones.. running legends with turn signal??
Alright guys I need your Help on this one... I have a 2008 crossbones and just put an order in for a set of legends air ride that should be here by the end of the week.. now in all my minor workings on this bike I have removed the front and rear turn signals with all wiring intact and my goal if i can get it figured out is to use my right and left turn signals on the handlebars to control my air ride... example right-raise and left-lower and I have a few questions??
1) how do i get the switches contact to stay connected without BLINKING or STAYING ON untell I release is that something to do with my turn signal module???
2) does anyone know what wires i need to the air ride??
this is my guess with out seeing the shocks yet
12+
12-
12+ when raise button is pushed
12+ when lower button is pushed
Any help would be much appreciated guys thanks!!!
1) how do i get the switches contact to stay connected without BLINKING or STAYING ON untell I release is that something to do with my turn signal module???
2) does anyone know what wires i need to the air ride??
this is my guess with out seeing the shocks yet
12+
12-
12+ when raise button is pushed
12+ when lower button is pushed
Any help would be much appreciated guys thanks!!!
Thread Starter
|
6th Gear
Joined: Jan 2009
Posts: 10
Likes: 0
thanks Joe What.. so the goal is to have it activated weather its raise or lower ONLY when the switch is actually being pushed without blinking??
....how do i get the blinking to stop??
....how do i make it so i dont have to push the button twice to activate and deactivate the switch??
....how do i get the blinking to stop??
....how do i make it so i dont have to push the button twice to activate and deactivate the switch??
Outstanding HDF Member
Joined: May 2008
Posts: 2,359
Likes: 2
so let me get this straight you want to run your turn signals and the air system of the same buttons? If so cant do it with what you have you would need a serious of latch relays i.e hit once and turn signals function hit it twice the air comes on etc...
Thread Starter
|
6th Gear
Joined: Jan 2009
Posts: 10
Likes: 0
alright i was looking in my service manual and found this wiring diagrams.. then it was easy there is a white/purple(left switch) and a white/brown(right switch) wire going from the switch to the tsm so i cut those wires and capped the end going to the module and now i have my raise and lower wires for the air ride that are only activated when the switch is being pressed and it does not blink anymore... perfect....... should be receiving them in a few days and ill get some pictures up
Thread
Thread Starter
Forum
Replies
Last Post
Reindeer
Ignition/Tuner/ECM/Fuel Injection
11
Sep 27, 2012 06:34 AM
