Re-install front fairing
Thread Starter
|
Cruiser
Joined: Oct 2007
Posts: 125
Likes: 0
From: upper marlboro,Maryland
Re-install front fairing
Has anyone heard about heavy duty inserts that replaces the brass threaded bosses on the fairing to tightup around the windshield. The standard ones seem to pull out if you tighten just alittle too much. would lioke the part number thanks.
Stellar HDF Member
Joined: Mar 2007
Posts: 2,034
Likes: 45
From: Michigan
your dealer should have the part number.. Im not sure they are heavy duty but I believe they are redesigned to screw in instead of being a molded in insert as stock.. Some good super glue or better yet some good epoxy should fix the ones you have ... Just remember its a brass insert in plastic holding the upper fairing and windshield together... No need for 100 lbs of torque 
Ultimate HDF Member
Joined: Aug 2008
Posts: 5,413
Likes: 17
From: eastern oklahoma
there must have been a design improvement on the newer models, cause i am not too gentle when tightening the three windshield screws. just that i don't get carried away either. good luck and hope you get it working for you.
Thread
Thread Starter
Forum
Replies
Last Post
