alarm system question
Thread Starter
|
Cruiser
Joined: May 2008
Posts: 125
Likes: 0
From:
alarm system question
I just put a LED tail light and turn signals on the ultra yesterday and now my alarm is acting up. When I push the fob it flashes like it is supposed to but it doesn't do anything as far as electrical shutdown. The lights will flash when the bike is moved and the alarm is armed but u can start it still and u couldn't before. When I turn the bike on after starting it with the alarm off the turn signals will flash a few times and the security key light on the speedo stays lit. The turn signals and everything else works as it should so I am confused. It was just changing the lights so I am not sure why this would cause a problem. It was a plug n play operation. No fuss, no muss or so I thought. I checked the fused and no issues there. Does anyone have any ides? I didn't think I would have to reset something but who knows
thanks
thanks
Thread Starter
|
Cruiser
Joined: May 2008
Posts: 125
Likes: 0
From:
ummmm no. Do I need to? oh and what is one lol. That wasn' t in the friggin directions. They were Kuryakin (sp?). They had connectors that plugged right into the factory plugs in the back. The front ones went into the factory connector after removing the old ones.
Last edited by parrothead306; Sep 23, 2009 at 05:27 PM.
Seasoned HDF Member
Joined: Jun 2006
Posts: 28,524
Likes: 3,953
From: Vermont
Thread
Thread Starter
Forum
Replies
Last Post
