pingle shifter shaft
pingle shifter shaft
Outstanding HDF Member
Joined: Dec 2007
Posts: 2,803
Likes: 11
From: El Paso, Texas
Never have used it, but it look's like a good product so I am going to order it. My shifter also rattles and it's a hassle taking it apart to grease it. Thought about putting a grease zerk between the shifter bushings, but I just don't want to drill into the inner primary case.
Road Master
Joined: Nov 2009
Posts: 997
Likes: 3
From: Charlotte, N.C.
There is a rubber bushing between the case and the shaft lever if you loosen the bolt and slide the shaft lever tighter against the rubber it will tighten the shaft up a bit, did this to mine stop the rattle
Thread Starter
|
Road Master
Joined: Nov 2007
Posts: 1,181
Likes: 7
From: tomball tx
hmmm! not on mine!! what a suprise!!
Thread
Thread Starter
Forum
Replies
Last Post
