Accessory Switch leads

Reply Subscribe

Thread Tools

Search this Thread

Apr 23, 2012 | 11:34 AM

Louie Champan

Thread Starter

Cruiser

Joined: Mar 2011

Posts: 186

Likes: 2

From: Newcastle, Wa.

Accessory Switch leads

I have a 2011 SG, and I'm trying to find out where the output (lead) is available from this switch? I think it comes out on a connector under the seat, but for the life of me I can't find it on the schematic in the Maint. Manual. Sure appreciate some advice if anyone knows where I can get a hold of that wire.

Thanks
Louie

Apr 23, 2012 | 11:54 AM

Nute

Road Master

Joined: Jan 2010

Posts: 881

Likes: 13

From: ONT

Yup under seat on top of or beside battery. Gray square plug with rubber cap on it. Should be orange on the inside once you remove the cap.

Apr 23, 2012 | 12:30 PM

mkguitar

Extreme HDF Member

Joined: Sep 2010

Posts: 14,744

Likes: 402

From: Phoenix '53, '88, '09 Big Twins

there may also be pins that are active with 'run" and brake lights, so if looking to tap in, make sure you have the correct pin selected.

Mike

Apr 23, 2012 | 01:33 PM

Louie Champan

Thread Starter

Cruiser

Joined: Mar 2011

Posts: 186

Likes: 2

From: Newcastle, Wa.

Thanks very muich.

Apr 23, 2012 | 03:59 PM

Harleypingman

Extreme HDF Member

Joined: Apr 2006

Posts: 10,449

Likes: 46

From: Roswell, GA

A schematic for a main wiring harness should show the connector. The 4-wire ACC connector will have very small embossed numbers identifying the wire chambers. The wire for the switched circuit is #3.

Carl