ape hanger issue
Thread Starter
|
Cruiser
Joined: Dec 2012
Posts: 103
Likes: 0
From: Mass
ape hanger issue
have been working on my apes recently. when i did the throttle cables(magnum chromite II) i got them all run with little issue but i cant seem to get the adjustments right. it always seems that it doesn't snap back quick enough. I've followed the instructions in my shop manual and also watched about 20 videos online, better but still not right. any tips? thanks!
Outstanding HDF Member
Joined: Jul 2010
Posts: 2,187
Likes: 11
From: Ladera Ranch, CA
I ran into this issue with my install. I determined it was how the cables were routed. I had too sharp of a turn going through the top of the nacelle. I ran a little test and pulled the cables and ran them outside the nacelle and adjusted them just to see if i got the snap that I was looking for and I did. That told me it was a routing issue. I ran them again avoiding any sharp turns and pinching and they now work.
Thread Starter
|
Cruiser
Joined: Dec 2012
Posts: 103
Likes: 0
From: Mass
I ran into this issue with my install. I determined it was how the cables were routed. I had too sharp of a turn going through the top of the nacelle. I ran a little test and pulled the cables and ran them outside the nacelle and adjusted them just to see if i got the snap that I was looking for and I did. That told me it was a routing issue. I ran them again avoiding any sharp turns and pinching and they now work.
Outstanding HDF Member
Joined: Jul 2010
Posts: 2,187
Likes: 11
From: Ladera Ranch, CA
I'm not sure about yours. Mine are different because I have cruise control, so there's no way to mix them up. Good luck!!
Thread
Thread Starter
Forum
Replies
Last Post
