Throttle slop
Thread Starter
|
Club Member
Joined: Nov 2005
Posts: 955
Likes: 2
From: Missouri
Throttle slop
Is a half inch play in the throttle too much? Just had different handlebars installed and it seems a bit sloppy. Never noticed it before but maybe it was there and I'm just now noticing it because of the new bars.
Thread Starter
|
Club Member
Joined: Nov 2005
Posts: 955
Likes: 2
From: Missouri
RE: Throttle slop
Did a search and found that some are saying that FI bike with electronic cruise control will have more throttle play. Some say it should not. I guess I am confused as to what to do.
Road Master
Joined: Mar 2006
Posts: 791
Likes: 0
From: Arizona
RE: Throttle slop
Sparky,
Even with a cruise control, there should be only a little play in the grip, but not half and inch! You can adjust this yourself if you choose to.
Even with a cruise control, there should be only a little play in the grip, but not half and inch! You can adjust this yourself if you choose to.
ORIGINAL: sparky_mo
Did a search and found that some are saying that FI bike with electronic cruise control will have more throttle play. Some say it should not. I guess I am confused as to what to do.
Did a search and found that some are saying that FI bike with electronic cruise control will have more throttle play. Some say it should not. I guess I am confused as to what to do.
Road Master
Joined: Mar 2006
Posts: 791
Likes: 0
From: Arizona
RE: Throttle slop
Identify the throttle cable from the retun cable. Pull back the rubber sleeve from the throttle cable under your RH grip. One cable is for the throttle the other one is for the throttle return. You'll only need to adjust the throttle cable. Using two wrenches, loosen the nut that locks the cable adjuster. Then, start turning the adjuster a few turns. Then move the grip around to check the amount of play. If the play lessen, then do a few more turns to the desired amount of play. Tighten the lock nut back with the two wrenches, slip the rubber sleeve back over the adjuster. You're done!
ORIGINAL: Phins74
OK HOW?
OK HOW?
Trending Topics
Road Master
Joined: Aug 2006
Posts: 944
Likes: 2
From: Tennessee
RE: Throttle slop
Mine feels spongy in the closed position, not what I am used to. I adjusted the cables the old fashioned way and found it to be better, then got the service manual and found that on cruise equipped bikes in addition to two wrenches I needed to use a multimeter, two banana peels, a curling iron, and a twelve pack just to adjust the d@mn cable. You also have to remove the left side cover! I adjusted it exactly like the manual says and now it feels spongy again,but by golly its adjusted right.
Stellar HDF Member
Joined: Sep 2006
Posts: 3,236
Likes: 95
From: lancaster, pa
RE: Throttle slop
What the heal is up with the sm for adj cruise control! I just did its like "normal" previously mentioned after cc was installed and its purfect. Maybe got luck or something to do with that roll off switch being in line with a section of the return cable?
