Do I need a Power Commander?
Would a Power Commander get me anything with this setup?
Since we're on the subject of tuners, PC is the only one I hear much about, are there others I should consider? How difficult are they to install? Any side effects, or things to watch out for?
If you don't want added hardware hanging off the bike, there are software based tuners that reprogram the very capable stock ECU to get the most out of the bike. They are better but maybe more $$$ than you like. For example the TTS and the Harley Race tuner, there are others. Some of these tuners allow the amateur (that knows his way around a laptop) to do a pretty good job tuning for economy or performance or drivability and make it easy to change the tune after you make motor upgrades and without resorting to dyno time.
If you really want to get the most, however, hire a good tuner, tell him what would make you happy, buy what he tells you, pay him to tune the bike.
Just about anything, including the $100 XiEDs, will get you something. The bang for your buck is subjective, however. Each system has its fans.
Here are a couple forums with more specific discussion, some pretty heated:
https://www.hdforums.com/forum/elect...-injection-55/
http://harleytechtalk.net/htt/index.php?board=13.0
http://www.1130cc.com/forums/forumdisplay.php?f=108
I ended up with a TTS and it is a pretty good system. Nothing to install on the bike, just connect a laptop to diagnostic port. There are pluses and minuses to every fueler or tuner, what's good for me may not be so good for you.
Last edited by ColdCase; Jul 30, 2009 at 03:42 PM.
If all you're ever going to do is the pipes and a/c, no you don't need the PC if you got a remap from the dealer.
If you plan on tuning it or adding a big bore kit or cams and headwork...you'll wish you had the powercommander.
The stage 1 remap the dealer does is designed for the SE slip-ons and a Stage 1 air cleaner. Since you have a full exhaust it is most likely running lean.
Trending Topics
What programers/tuners do is replace these tables with something they think is more closer to ideal, no compromises. Most of the work is coming up with the best tables for the specific engine with its modification and sensor characteristics, some trial and error is involved. Replace the factory tables with the new ones and the ECU will do its thing to try to run the engine at the new ideal conditions and everything is good.
The other approach is to add on hardware that adjust what sensors are feeding the ECU and/or the fueling signals sent to the injectors. Some disable the close loop completely and force certain conditions, developed on a dyno for a system close enough to what you're running. The simplest ones, like the XiED, tricks the ECU in thinking the motor is running a little leaner than it really is, so the ECU ends up feeding it more fuel and you end up with a slightly richer mixture when operating closed loop (idle and cruising).
Again, the seat of pants difference is subjective and therefore the bang for buck is widely debated, the effectiveness or how ideal each system gets is also widely debated. How much do you want to pay for that last bit of HP or mpg... a drag racer may be willing to pay a lot.
Last edited by ColdCase; Jul 30, 2009 at 05:33 PM.
The Best of Harley-Davidson for Lifelong Riders



