HOLY F%$ Yea those are going to suck to wire. Mine sucked with 90 angles. If I have to take all the wiring out and redo it I'll use tire shine like FUQUA did. Don't know why I didn't think of that and I read his thread after I wired mine of course.

 

Well crap.... ... I most likely will be headed over to Missoula this next weekend.... Went up to the bike show Saturday... found out yesterday that the bike belonging to another of my riding buddies did well in the competition.

 

I know. <----------me thinking of doing it.


However, I like the bars you got and was going to do that route...but I really fell in LOVE with the RC bars I posted and also...why I haven't committed to doing the work. I know it is just plain going to suck, but you might have a great point with the tire shine. I also think something sticky like grease might work well and if it is dielectric it wouldn't harm the coating.....hmm...

 

Oh well! I've been to freakin busy so who knows if I get to it next weekend.

 

Dielectric grease would get super messy and a PIA to clean afterward!

 

Good point.

 

I routed my wires through my cables by tying a single strand of bow-string (~50lb /strand pull strength... small and waxed)... and taping off all the holes I didn't want the string to come out of, and blew the string through the bars with my air compressor, and then pulled the wiring through with the string...

Hey Jaron, I still have a couple different sizes and lengths of that braided nylon wire loom stuff....

 

I may need that if I have to pull all the wires! That would be awesome!! Since I couldn't find it anywhere out here.

 

here mon check this vid out these are sick sick he wires em no probs at all
http://www.youtube.com/watch?v=QJTtmaZ91os

http://www.youtube.com/watch?v=XuAaIPgO-ao

 

you can order bars w/ wires in em already too this guy rocks
i bought mine from him love em