siren install HELP
Thread Starter
|
Advanced
Joined: Mar 2007
Posts: 94
Likes: 0
From: casper wy
siren install HELP
help i have the radio shack siren. i hooked the red wire to the brown and the black to the green. when i turn the ignition on the siren comes on. what went wrong? 08 ultra. thanks Dale in Casper
Road Master
Joined: Nov 2007
Posts: 1,136
Likes: 0
From: Tri-Cities, Washington
RE: siren install HELP
Just did this this afternoon - not a problem here. Sure you have the black wire in the right place? Mine went in the center hole. The wire looked green with a darker stripe, the right wire (empty space) looked darker with a greenish stripe. Don't know what else it could be.
Thread Starter
|
Advanced
Joined: Mar 2007
Posts: 94
Likes: 0
From: casper wy
RE: siren install HELP
yes black wire in middle red to brown. i looked in the service manual. the brown is fused power the middle is alarm signal from modual and the thrid is ground. dale
Cruiser
Joined: Aug 2007
Posts: 160
Likes: 0
From: Seattle area
RE: siren install HELP
Hmmm... sounds like you have it wired correctly. Are you sure you're on the right connector? Left side? Do the turn signals flash as well? The siren should "chirp" as you turn the ignition on and off or arm/disarm. Can you still start the bike with the siren going off?
Road Master
Joined: Nov 2007
Posts: 1,136
Likes: 0
From: Tri-Cities, Washington
RE: siren install HELP
Danng - any chance it's a variation of the siren but not the right one? From my receipt, #2730079.
Edit - something else to think about - it's a $6.00 part after all, maybe the siren is shorted?
Edit - something else to think about - it's a $6.00 part after all, maybe the siren is shorted?
Thread
Thread Starter
Forum
Replies
Last Post
