Question on Neutral Light
Question on Neutral Light
I was working on the bike today - installed my new crash bar and the Fullsac dual conversion. Everything went fine....But, when I went for a short test ride and came home to park the bike, I realized that my neutral light was not working.
I've owned several Harley's and never had an issue with the neutral switch. Anyone had an issue with the Neutral Switch going bad?
Could it be something else?
Thanks for any comments.
I've owned several Harley's and never had an issue with the neutral switch. Anyone had an issue with the Neutral Switch going bad?
Could it be something else?
Thanks for any comments.
Grand HDF Member
Joined: Feb 2005
Posts: 4,307
Likes: 9,428
From: Twin Cities Minnesota
RE: Question on Neutral Light
It is on top of the transmission. Take it out and clean it off with brake cleaner, sometimes they get dirty and the ball does not make contact. It is only a metal ball with a spring that completes the circuit to ground. Mine has acted up a couple of times.
Tourer
Joined: Oct 2006
Posts: 486
Likes: 0
From: Texas!!
RE: Question on Neutral Light
You probably just dislodged or damaged the wire going to the neutral switch.
As jeepster09 said, it's on top of the trany just below where you working on the rear cylinder exhaust port.
As jeepster09 said, it's on top of the trany just below where you working on the rear cylinder exhaust port.
Thread
Thread Starter
Forum
Replies
Last Post
