When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
John, there are many pages in the FSM about diagnosing cruise control problems. They are the best way to deal with issues, clear and easy to work through.
My '94 is a little different than a "97 but in my manual there's a section that walks you through with a flow chart.
That being said when mine would cut off intermittently I traced every wire, checked continuity and tested over and over without passing the cruise check. I gave up and put it back together. In the spring it worked fine. It can be a real PITA to diagnose.
Today I checked to see if the rear brake switch is working, and it seems to be, or at least the brake lights are working.
Cruise shuts off fine when front brake applied
Works fine with the front brake...doesn't work with the back brake, but the brake lights work...it is almost a given that the wire from the back brake switch to the module has a bad connection or is broken.
Got a schematic? In General, every other cruise control on every other automotive application only taps into the brake light circuit. I doubt HD did it differently. So, if you "tapped" the rear brake, did the rear brake light actually come on? You know that is a pressure activated switch, so a light tap that doesn't build sufficient pressure to activate the switch will not turn that circuit on. Try it again and don't "tap" the brake, like you would on a car (which typically use a mechanical switch like your front brake, not a hydraulic switch like your back brake), but stop on the rear brake hard and see if it goes off.
Got a schematic? In General, every other cruise control on every other automotive application only taps into the brake light circuit. I doubt HD did it differently. So, if you "tapped" the rear brake, did the rear brake light actually come on? You know that is a pressure activated switch, so a light tap that doesn't build sufficient pressure to activate the switch will not turn that circuit on. Try it again and don't "tap" the brake, like you would on a car (which typically use a mechanical switch like your front brake, not a hydraulic switch like your back brake), but stop on the rear brake hard and see if it goes off.
Yep brake light comes on.
I could feel the bike working against the rear brake ,, if it was working it should have activated I'm sure.
Works fine with the front brake...doesn't work with the back brake, but the brake lights work...it is almost a given that the wire from the back brake switch to the module has a bad connection or is broken.
Not necessarily. With the front brake, the light comes on before the brake starts working. With the back brake, the brake starts working before the light comes on.
7 Surprising Harley-Davidson Products that Are Not Motorcycles
Slideshow: The bar-and-shield logo shows up on far more than motorcycles, some of the company's most unexpected products have nothing to do with riding.
Slideshow: From the troubled AMF years to modern misfires, these bikes earned reputations for reliability issues, questionable engineering, or disappointing performance.
Crazy Bunderbike Build Looks Amazing, But Is It Impossible to Ride?
Slideshow: The Swiss custom shop has taken a Harley Softail and stretched it into something so long and low that it looks closer to a rolling sculpture than a conventional motorcycle.
Engraved Rebellion: Inside Bundnerbike's Glam Rock II
Slideshow: A standard cruiser becomes an intricate metal canvas in the hands of a Swiss custom house known for pushing Harley-Davidson platforms far beyond their factory brief.
Slideshow: Harley-Davidson's challenges aren't abstract; they show up in dropping shipments, shrinking dealer traffic, and strategic decisions that aren't yet translating into growth.