help with HD touring pullback bar install
Road Captain
Joined: Jun 2008
Posts: 613
Likes: 2
From: Tallmadge, Ohio
I just installed 12.5 Chubbies (wo577) on my 08flhx and love them. I was also feeling the strain on my neck/shoulders and this was one of the best things I could have done. I did get the harley diamondback clutch and brake lines (+6) and didn't need the extension for the tbw. With 20% off, you can get the cables for about 250.00 and wire extension kit for about 70.00(shipped). The bars were about 195.00 so that brings the total up to about 515.00 and less if you only get the clutch and top stock brake line. You can do the job if you have time and patience. If not, find an INDY or mechanic to do it on the side. Should only cost another 200.00 for that labor if you go in with everything. (oh, also need brake fluid and tranny fluid so add another 20.00).
Novice
Joined: May 2010
Posts: 18
Likes: 2
From: Portland, Oregon
Thank you very much FLHX08! you da man, take your advise and take my time to do it right. Yes the local dealer charges about 4 hours working plus parts; it's roughly $550-$600. it would burn my pocket,LOL,
Thread Starter
|
Road Captain
Joined: Feb 2008
Posts: 602
Likes: 2
From: SE Michigan
glad it worked out and I was of some assistance. sorry i didn't come back as the summer is the time to ride. I haven't been here to notice the posts after my last post.
Road Warrior
Joined: Nov 2008
Posts: 1,636
Likes: 7
From: Jackson, Michigan
What did you guys do about mirrors - I like the 575s but not crazy about switching out mirrors - but I like to use them. I guess my question is if you leave them stock can you see them properly? I plan to install them and lean them back towards me - not so much interested in lifting my hands.
Cruiser
Joined: Mar 2007
Posts: 143
Likes: 1
From: El Reno,OK
Ok, here is a little secret, as a wrench the easyist way, is to remove the 2 bolts on the sides of the switch cover, remove the outer fairing, take the 4 bolts out of the spot light bracket, unplug it, and set a side, remove the crome cover, lift up and back on the inter fairing , just have to move it back enough to get to the bolts,then put it back together when done, ,Its a lot easer and faster than removing the ign switch and radio, just to get to the handlebar bolts
Thread Starter
|
Road Captain
Joined: Feb 2008
Posts: 602
Likes: 2
From: SE Michigan
sorry for the long delay on posting a pic but here you go. no problem using the stock fairing mirrors, which is why I went with these bars, along with not being a fan of the monkey bar thing. why have a full fairing if I want my hands up in the wind, but to each their own as they say.
Stage I
Joined: Aug 2011
Posts: 1
Likes: 0
HD Forum Stories
The Best of Harley-Davidson for Lifelong Riders
7 Surprising Harley-Davidson Products that Are Not Motorcycles
Verdad Gallardo
8 Best Harley-Davidson Motorcycles Ever
Pouria Savadkouei
10 Worst Harley-Davidson Motorcycles Ever
Pouria Savadkouei
Killer Custom's Jail Break Is The Breakout That Refused to Blend In
Verdad Gallardo
Crazy Bunderbike Build Looks Amazing, But Is It Impossible to Ride?
Verdad Gallardo
Harley-Davidson Reveals Super Cool Cafe Racer Concept
Verdad Gallardo
Engraved Rebellion: Inside Bundnerbike's Glam Rock II
Verdad Gallardo
10 Motorcycles You Should Never Buy
Joe Kucinski
10 Things Harley-Davidson Needs to Fix in 2026
Verdad Gallardo
Road Warrior
Joined: Nov 2008
Posts: 1,636
Likes: 7
From: Jackson, Michigan
Any luck donig a search? I know it may take a few posts before you can post a thread - good place to get you post count up is on the welcome thread - go there anyway and say hi - good place to get to know folks and bump that post count. Not sure how many you have to get to - I thought it was not too many, but once you are approved - start a thread with your question on the touring board and you'll get some answers.
Thread
Thread Starter
Forum
Replies
Last Post
